Model NO.
WMR-268-Q
Chip
CMOS
Waterproof Grade
IP68
Transport Package
Neutral Box
Specification
CE
Trademark
Wemaer
Origin
China
HS Code
8525801390
Production Capacity
150000/Month
Applicable Model:
Car, Sightseeing Car
Shell Material:
ABS Plastic
Display Type:
Reverse Image
Interface:
RCA
Function:
Night Vision, Waterproof, Dustproof, Shockproof
Definition:
420TVL
1.Product introduction
Built-in Can rear view camera is through the acquisition vehicle Can network data on the steering wheel rotation, and then converted to the corresponding trajectory camera images.The product contains most of the models cars (in the appendices form has included) which helps the driver to easily parking vehicles.
3.Installation Guides:
1.Install the camera on the suitable position.
2.The power extention wire connect to camera red DC port.The other end,red small line connect to back light
anode,black line to back light cathod.
3.Six- meter control line connect to back camera video AV port,and control -red line connect to back light
anode.The other end connect to reverse video input of navigator or display screen.Red small line connect to
reverse detection signal line of navigator.
4.Let OBD wire connect to car OBD test port(usually on the lower left of the steering wheel), then start the
car,access to the reverse gear
4.Accessories:
1) Extention wire of video AV line
2) Power extention cable
3) OBD extention cable
4) Instruction book
Built-in Can rear view camera is through the acquisition vehicle Can network data on the steering wheel rotation, and then converted to the corresponding trajectory camera images.The product contains most of the models cars (in the appendices form has included) which helps the driver to easily parking vehicles.
2.Product specification
| Chip sensor | PC3089 |
| Image format | Ntsc |
| Effective Pixel | 720 * 480 |
| Working voltage | 12V |
| Working temperature | -20ºC~70ºC |
| Working humidity | 15-65%RH |
| Storage temperature | -30ºC~75ºC |
3.Installation Guides:
1.Install the camera on the suitable position.
2.The power extention wire connect to camera red DC port.The other end,red small line connect to back light
anode,black line to back light cathod.
3.Six- meter control line connect to back camera video AV port,and control -red line connect to back light
anode.The other end connect to reverse video input of navigator or display screen.Red small line connect to
reverse detection signal line of navigator.
4.Let OBD wire connect to car OBD test port(usually on the lower left of the steering wheel), then start the
car,access to the reverse gear
4.Accessories:
1) Extention wire of video AV line
2) Power extention cable
3) OBD extention cable
4) Instruction book
Send Message
