Solas Marine Lifesaving Equipment Pilot Boat Ladders with Certificate, Pilot Ladder, Embarkation Ladder

Solas Marine lifesaving equipment Pilot Boat Ladders with certificate

Pilot ladder and embarkation ladder are one type of rope ladder, usually made by hard wood and used for embarking and disembarking pilots and crew. It is an important tool for marine safety. With spreaders step (Preventer Step) and magnet, pilot ladder and embarkation ladder could work safety under kinds of sea conditions.

Pilot ladder
Standard: SOLAS 1974 as amended, Reg.V/23 and X/3
                IMO Res.A.1045(27), IMO MSC/Circ.1428,                            ISO799(2004)

Embarkation ladder
Standard: SOLAS 1974 as amended, Reg.III/4, III/11, III/34, and X/3;
                IMO ResMSC.36(63). (1994 HSC code), IMO Res.MSC.48(66)(LSA code), IMO
                Res.97(73)(2000HSC code), IMO Res. MSC.81(70), ISO5489(2008)

Made up of Rubber step (the last four steps), Wood step, Spreader (Preventer Step), Step fixing piece, rope.
Rope:

Ropes should be mold-resistant manila or heat-treated polyester rope with polypropylene core and should not be covered. Ropes shall be of a diameter which is no less than 57mm in circumference, and have a braking strength more than 24KN.
Steps: The distance of inner edge of side ropes should be more than 400mm, the width of step is no less than 115mm, and thickness no less than 25mm. The steps should be non-slip, hard wood steps without knot and equally spaced at 330±20mm.

Rubber Step:
The bottom 4 steps may be made f resilient synthetic raw material or rubber if it is of sufficient strength and stiffness. Rubber steps should be of the same required dimensions as the wooden steps.

Spreader:
Spreader shall have the same specifications as normal steps, but length of spreader shall not be less than 1.8 meters.

Step Fixing Piece:
Must be wood or plastic

Fastening Hardware:
Fastening hardware for rope and steps must be corrosion resistant, or made of similar material treated corrosion resistance.