MWR-1
7/24 After-Sales Service
1 Year
350kg
30cm
Foldable
Aluminum
CE
1053*988
350kg
40kg
Electric
1124mm
1416 mm
62 mm
Anti-Skip Platform
xinder
Wooden or Carton Box
40KG
Jiangsu. China
84289090
Product Description
1. Ramp Introduction
Manual wheelchair ramp can be applied for low-floor city bus, and it is installed under the side of passenger door' step. When the bus arrives at bus station, the driver unlocks the front cover and pulls out the platform. After the platform reaches final position, its rear-end will raise to floor to eliminate height gap so as to convenient for wheelchair to access the bus. After the wheelchair gets on the bus, retract the platform manually.
This manual wheelchair ramp is fixed under chassis by 4 brackets. These brackets are composed of 16 bolts (M10*20), nuts, spring washers and flat washers (diameter is 10mm).
Because the bracket connects with the ramp frame by swallow - trough, we can adjust the front and the rear position of brackets to make the front end of the manual wheelchair ramp exceed the front end of passenger door threshold 10mm. When the rear end of ramp extend fully and be raised, the ramp should be locked.
2. Main Technical Parameters
2. Technical Function
Drive mode: Manual
Own weight: 40Kg
Max. Loading capacity: 350 Kg
Raising Height of Rear-end: 55mm
Safety:
Ø Adopt anti-skid aluminum plate on the surface of platform
Ø With danger sign on the outer-edge of ramp
3. Installation Requirement
Min space required to install ramp unit: mm
Manual wheelchair ramp can be applied for low-floor city bus, and it is installed under the side of passenger door' step. When the bus arrives at bus station, the driver unlocks the front cover and pulls out the platform. After the platform reaches final position, its rear-end will raise to floor to eliminate height gap so as to convenient for wheelchair to access the bus. After the wheelchair gets on the bus, retract the platform manually.
This manual wheelchair ramp is fixed under chassis by 4 brackets. These brackets are composed of 16 bolts (M10*20), nuts, spring washers and flat washers (diameter is 10mm).
Because the bracket connects with the ramp frame by swallow - trough, we can adjust the front and the rear position of brackets to make the front end of the manual wheelchair ramp exceed the front end of passenger door threshold 10mm. When the rear end of ramp extend fully and be raised, the ramp should be locked.
2. Main Technical Parameters
| Model | Drive mode | Platform net size (L*W) | Installation |
| MWR-1 | Manual | 1054*988(Standard) | Installed under the passenger door, rear-end of ramp will rise to eliminate height of threshold of passenger door and level with bus floor. |
| Model | Platform Net Size (A×B) | Overall Width (C) | Overall Height (D) | Overall Length (E) | Loading Capacity | Own Weight |
| MWR-1 | 1054*988 | 1124 | 62 | 1416 | 350 Kg | 40 Kg |
2. Technical Function
Drive mode: Manual
Own weight: 40Kg
Max. Loading capacity: 350 Kg
Raising Height of Rear-end: 55mm
Safety:
Ø Adopt anti-skid aluminum plate on the surface of platform
Ø With danger sign on the outer-edge of ramp
3. Installation Requirement
Min space required to install ramp unit: mm
| Model | Net Width of Door | Accessible Width Under Vehicle | Accessible Height Under Vehicle | Accessible Depth Under Vehicle | Remark |
| MWR-1 | 998 | 1090 | 200 | 1415 | |
