Proximity Switches with SPDT Contact (MPS-E-10)

MPS-E-10 proximity switches, named as magnetic sensor or switches, with SPDT contact, and plastic or SUS304 housing, 300mm length or client required cable...

Switching voltage: 100Vdc, 200Vac
Switching Current: 250mA
Carry Current: 1.5A
Power Rating: 5W or 10W
Operating Temperature Range: -10~125 degree C
Wire or Cable: 300mm UL1430 AWG24

Inductive sensors are used when the target is metal. These are the most widely used switches in industry today. The inductive proximity switch consists of 4 main components: coil, oscillator, detection circuit and solid state switching device. The oscillator creates a high frequency field that is emitted from the sensing face. When a metal target enters that field, eddy currents are induced in the metal target (hence the term INDUCTIVE). Energy is required from the oscillator to maintain the eddy currents in the target.


INDUCTIVE PROXIMITY SWITCHES
Technical Specifications of Barrel Shaped AC TYPE
Model
IPS-A-2
-1270
IPS-A-2.5
-1470
IPS-A-3
-1670
IPS-A-5
-1870
IPS-A-6
-2265
IPS-A-7
-2565
IPS-A-10
-3065
Size mm
M12x70
M14x70
M16x70
M18x70
M22x65
M25x65
M30x65
Operating Voltage(VAC)
 

Item	Technical Parameter
Pressure Setting Range	Automatic Reset:0.1Mpa-3.05Mpa;Manual reset:2.5Mpa-3.4Mpa
Electrical Ratings	120/240VAC,375VA;28VAC/VDC,2A 120VAC, 5.8FLA, 34LRA; 240VAC, 2.9FLA, 15LRA
Ambient Temperature and Humidity	-35ºC+120ºC;less than 95% RH
Contact Resistance	Less than 100mΩ
Insulation Resistance	More than 100mΩ
Dielectric Voltage Withstand	Withstand 1500vac for one minute without breakdown
Burst Pressure	35Mpa for one minute without body rupture and seals failure
Leakage	Total maximum allowable leak rate of 7*10-6cc/sec of at least 70% helium at 1.0Mpa
Durability	100,000 cycles(automatic);6,000 cycles(Manual)
Flame Rated	UL94V-0