Antivibration cylindrical mounts are made of the finest rubber grades and metal which meets the most stringent specifications for efficient vibration isolation and noise damping over a wide range of frequencies when controlling motion.
Cylindrical antivibration mounts, also known as cylindrical bobbins or bobbin mounts, are widely used to block active and passive vibration, as well as to regulate shock and structure-borne noise. Cylindrical vibration isolators can be used in both shear and compression designs.
Each cylindrical antivibration mount comes with natural rubber and specialized compounds as shown below.
Additional compounds for the manufacturing of our antivibration mounts are available:
We offer Chloroprene (Baypren, Neoprene) antivibration cylindrical mounts, Ethylene Propylene Terpolymer, Ntrile Butadine (Perbunan), Styrene Butadiene, Butyl, Polyurethane, Silicone Rubber and Fluorocarbon (Viton) antivibration cylindrical mounts.Bobbins are devices for making elastic anchorings or fixings. They can be used in a wide variety of applications, particularly for elastic suspensions and anti vibration isolation of machines and different mechanical organs. Bobbins are made of a block of rubber with two parallel metal parts at the end which enable it to be fixed with nuts. The rubber block may be cylindrical in cases requiring greater load capacity or as a diabolo when greater elasticity is required in all directions.
Depending on the size of the rubber block, the bobbing has more or less elasticity, which is greater particularly in all directions perpendicular to its axis (shear). The bobbing thus makes it possible to make joins which permit major relative movements, up to several millimetres (in the case of heat expansion, chassis deformations, etc.). It serves very well for the vibration isolation of machines where the vibrations are perpendicular to their axis, unless these stresses are too much when applied in this direction.
Applications
Suitable for installation on small motor-pumps, motor-ventilators, driers, sieves, compactors, washing machines, electrical motors, on-board control panels, measuring apparatuses, control cabinets, microphones, fluorescent tubes, etc.
- Easy to install
- High elasticity (particularly transversal)
- Economical
